Hi,welcome to CLEAN-LINK!

Washable air filter cleaning step


High temperature panel filter is the most commonly used air filter in air conditioning systems. It can be made into filters with different effects according to different materials. For example, the primary filter made of synthetic fiber material has low initial resistance and can be repeatedly cleaned. It is more economical in the initial effect filter, so what is the cleaning step of this initial effect filter?

First of all, you need to open the suction grille inside the device. Just press and hold the buttons on both sides and gently pull down. You should be careful when going down. Don't use too much force, otherwise it may be broken. More troublesome.

Secondly, you need to pull the device out. Some people may feel that the device is not easy to take out. In fact, the method is very simple. Just drag the hook on the air filter and then tilt it a little, it will be easy to pull the device out. It is very simple. .

The dust of the air filter must be cleaned. You can use a special vacuum cleaner to dispose of the dust, or you can rinse it with warm water. However, there may be some dust with strong adhesion in some cases, which requires a lot of warm water to rinse. If there is more dust, there is another way to use the brush directly, but be sure to use a soft brush, preferably with a neutral detergent. After cleaning, you need to clean the water and put it on the balcony to dry. Use it later.

After cleaning, install the device, close the suction grille, and press the signal reset button on the control panel of the air filter device. This cleaning process is completed.

Note: Do not use water that is hotter than 50 degrees Celsius. Because the water is too hot, it may cause the device to fade or be deformed. If it needs to be dried, it should not be dried directly on the fire. It is good to let go of the ventilation place directly.

Guest Book